Monday, July 8, 2013

Heavy Stubber Conversion

I am converting a Heavy Stubber for our henchman/son's character in our Dark Heresy campaign.


To start off with, I clipped out the receiver form a plastic Necromunda Goliath Autogun.


Then clipped out the arm, hand grip and stock from a Wargames Factory Shock Troops weapon arm.


Finally I separated the barrel and ammo belt from the remaining receiver on a Necromunda Heavy Stubber left over form a previous conversion.


Completed Heavy Stubber!

Friday, July 5, 2013

RPG Mobs - Rak'gol WIP


Here is a proof of concept for a group of Rak'gol figures I will be converting. I am using a HeroClix Brood figure as the base. The finished models will be boxier and less "lizard-like" than illustrations in Rogue Trader: The Koronus Bestiary, but I think they will make a good representation.

Another angle 
The pieces were fiddly enough, I was having a hard time using poster-tac to hold everything together so I glued this one together. I intend to dremel out sockets for the "legs" for a better fit.


I have already sourced enough Brood figures and Tyranid bitz to make 16 Rak'gol in the various ranks depicted in the rule book.

Tuesday, July 2, 2013

Deathwatch Character Showcase - Blood Raven Techmarine


This is the techmarine for our Deathwatch campaign. Pretty straight forward. Only a couple minor mods. Although I did magnetize the entire servo-harness!


I removed the right arm and replaced it with a Grey Knight pointing arm and a Deathwatch shoulder pad. The figure is an older figure and I am using a servo-harness and servo-arms from a newer model (pre-finecast).  The right claw head had to be removed and rotated to look proper in the low-slung position.


The servo-harness has 4 magnetized "hard-points" to allow for optional load-outs and representing character advancement. I glued a small piece of plasticard on the arm of the low-slung servo-arm as the metal bit was a tad too heavy for the magnet to lock it in place. The plasticard "extension" sits against the side wall of the servo-harness and prevents the servo-arm from rotating.